FreeBSD 8.0 dmesg

Here is a sample dmesg for FreeBSD 8.0 booting from USB storage

         __  __                      _ _
        |  \/  | __ _ _ ____   _____| | |
        | |\/| |/ _` | '__\ \ / / _ \ | |
        | |  | | (_| | |   \ V /  __/ | |
        |_|  |_|\__,_|_|    \_/ \___|_|_|
 _   _     ____              _
| | | |   | __ )  ___   ___ | |_ 
| | | |___|  _ \ / _ \ / _ \| __| 
| |_| |___| |_) | (_) | (_) | |_ 
 \___/    |____/ \___/ \___/ \__| 
 ** MARVELL BOARD: SHEEVA PLUG LE 

U-Boot 1.1.4 (Sep 14 2009 - 15:36:37) Marvell version: 3.4.19

U-Boot code: 00600000 -> 0067FFF0  BSS: -> 006CFB00

Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz 

DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000   size 256MB 
DRAM CS[1] base 0x10000000   size 256MB 
DRAM Total size 512MB  16bit width
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:512 MB
Flash:  0 kB

CPU : Marvell Feroceon (Rev 1)

Streaming disabled 
Write allocate disabled


USB 0: host mode
PEX 0: interface detected no Link.
Net:   egiga0 [PRIME], egiga1
Hit any key to stop autoboot:  3
Marvell>> usb start

(Re)start USB...
USB:   scanning bus for devices... 3 USB Device(s) found
       scanning bus for storage devices... 1 Storage Device(s) found
Marvell>> fatload usb 0:1 0x900000 /kernel.bin

reading /kernel.bin
.........................................................................
.........................................................................
.........................................................................
.........................................................

2835956 bytes read
Marvell>> go 900000

## Starting application at 0x00900000 ...
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2009 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 
	The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 8.0-RELEASE #4 r199878M: Wed Dec  9 15:23:17 UTC 2009
    root@sheeva.home:/usr/obj/arm/usr/src/sys/SHEEVAPLUG_UFSROOT
Preloaded elf kernel "elf kernel" at 0xc0bce098.
CPU: Feroceon 88FR131 rev 1 (write-through core)
  WB enabled EABT branch prediction enabled
  16KB/32B 4-way Instruction cache
  16KB/32B 4-way write-back-locking-C Data cache
real memory  = 536870912 (512 MB)
Physical memory chunk(s):
00000000 - 0x8fffff, 9437184 bytes (2304 pages)
0xcc3000 - 0x1f64bfff, 513314816 bytes (125321 pages)
avail memory = 520519680 (496 MB)
SOC: (0x6281:0x02) Marvell 88F6281 rev A0, TClock 200MHz
null: <null device, zero device>
random: <entropy source, Software, Yarrow>
mem: <memory>
nfslock: pseudo-device
mbus0: <Marvell Internal Bus (Mbus)> on motherboard
ic0: <Marvell Integrated Interrupt Controller> at mem 0xf1020200-0xf102023b on mbus0
timer0: <Marvell CPU Timer> at mem 0xf1020300-0xf102032f irq 1 on mbus0
timer0: [FILTER]
rtc0: <Marvell Integrated RTC> at mem 0xf1010300-0xf1010307 on mbus0
rtc0: registered as a time-of-day clock (resolution 1000000us)
gpio0: <Marvell Integrated GPIO Controller> at mem 0xf1010100-0xf101011f irq 35,36,37,38,39,40,41 on mbus0
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
uart0: <16550 or compatible> at mem 0xf1012000-0xf101201f irq 33 on mbus0
uart0: [FILTER]
uart0: fast interrupt
uart0: console (115740,n,8,1)
uart1: <16550 or compatible> at mem 0xf1012100-0xf101211f irq 34 on mbus0
uart1: [FILTER]
uart1: fast interrupt
ehci0: <Marvell Integrated USB 2.0 controller> at mem 0xf1050000-0xf1050fff irq 48,19 on mbus0
ehci0: [FILTER]
ehci0: [MPSAFE]
ehci0: [ITHREAD]
ehci0: 5.24 GL USB-2 workaround enabled
usbus0: EHCI version 1.0
usbus0: set host controller mode
usbus0: <Marvell Integrated USB 2.0 controller> on ehci0
mge0: <Marvell Gigabit Ethernet controller> at mem 0xf1072000-0xf1073fff irq 12,13,14,11,46 on mbus0
mge0: bpf attached
mge0: Ethernet address: 00:50:43:01:ca:a2
miibus0: <MII bus> on mge0
e1000phy0: <Marvell 88E1116R Gigabit PHY> PHY 0 on miibus0
e1000phy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
mge0: [MPSAFE]
mge0: [ITHREAD]
mge0: [MPSAFE]
mge0: [ITHREAD]
Timecounter "CPU Timer" frequency 200000000 Hz quality 1000
Timecounters tick every 1.000 msec
vlan: initialized, using hash tables with chaining
lo0: bpf attached
usbus0: 480Mbps High Speed USB v2.0
ugen0.1: <Marvell> at usbus0
uhub0: <Marvell EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus0
uhub0: 1 port with 1 removable, self powered
ugen0.2: <vendor 0x05e3> at usbus0
uhub1: <vendor 0x05e3 USB Hub 2.0, class 9/0, rev 2.00/7.02, addr 2> on usbus0
uhub1: 4 ports with 4 removable, self powered
ugen0.3: <Kingston> at usbus0
umass0: <Kingston DataTraveler 2.0, class 0/0, rev 2.00/1.00, addr 3> on usbus0
umass0:  SCSI over Bulk-Only; quirks = 0x0000
umass0:0:0:-1: Attached to scbus0
(probe0:umass-sim0:0:0:0): Down reving Protocol Version from 2 to 0?
pass0 at umass-sim0 bus 0 target 0 lun 0
pass0: <Kingston DataTraveler 2.0 PMAP> Removable Direct Access SCSI-0 device 
pass0: 1.000MB/s transfers
GEOM: new disk da0
da0 at umass-sim0 bus 0 target 0 lun 0
da0: <Kingston DataTraveler 2.0 PMAP> Removable Direct Access SCSI-0 device 
da0: 1.000MB/s transfers
da0: 954MB (1953792 512 byte sectors: 64H 32S/T 954C)
Trying to mount root from ufs:/dev/da0s2
ct_to_ts([2009-12-10 21:49:52]) = 1260481792.000000000
start_init: trying /sbin/init
Enter full pathname of shell or RETURN for /bin/sh: 
#