Now I have access via serial terminal to the SheevaPlug but when the system finishes booting it runs a script and this script launches a message on the screen and not get out of it preventing me from running any command and even restore the configuration file interface inside linux .
Would anyone have an idea of what it can do?
The print of the screen is
Configuring network interfaces.../etc/network/interfaces:15: misplaced option
ifup: couldn't read interfaces file "/etc/network/interfaces"
Starting portmap daemon....
Setting console screen modes and fonts.
cannot (un)set powersave mode
INIT: Entering runlevel: 2
Starting enhanced syslogd: rsyslogd.
Starting system message bus: dbus.
Starting OpenBSD Secure Shell server: sshd.
Processing INI file (/root/ixia/temp/endpoint.ini).
Performance Endpoint, Version 7.10 SP5 (Retail)
Copyright (c) Ixia, 2003-2011.
Copyright (c) NetIQ Corporation, 1995-2003.
U.S. Patents 5,838,919, 5,881,237, 5,937,165, 6,061,725, 6,397,359,
Other Patents Pending.
Endpoint INI information in use:
All available protocols are enabled.
All consoles may run tests on this endpoint.
Security Auditing: NONE
Audit filename: /root/ixia/temp/endpoint.aud
Notice: Can't use adjtimex() function to retrieve the NTP synchronized system clock. For external clock synchronization, we will use the gettimeofday() function instead.
CHR0503: Notice: unable to register with the Ixia Discovery Server.
Support for IP Multicast is enabled.
Support for disabling and enabling TCP's Nagle Algorithm is available.
Support for disabling and enabling generation of the UDP checksum is available.
Support for setting the Maximum Segment Size is available.
Support for TCP protocol has been started.