Hi,all,help me.
I downloaded uImage and uInitrd from Debian HOWTOs Kirkwood
SheevaPlug Installation(
http://www.cyrius.com/debian/kirkwood/sheevaplug/install.html).
I successfully installed this debian on usb drive to sheevaplug .
But, I could not installed this debian on usb drive to nimbus development kit.
In sheevaplug, debian installer shows "Manual" in Partition disks part.
Then I can select usb drive partitions.
But,in nimbus, I cannot select manual and select partitions.
Debian installer shows only "Undo changes to partitions" and x
"Finish partitioning and write changes to disk"
In sheevaplug, debian installer shows Partition disks message as follows.
lqqqqqqqqqqqqqqqqqqqqqqqqu [!!] Partition disks tqqqqqqqqqqqqqqqqqqqqqqqqqk
x x
x The installer can guide you through partitioning a disk (using x
x different standard schemes) or, if you prefer, you can do it x
x manually. With guided partitioning you will still have a chance later x
x to review and customise the results. x
x x
x If you choose guided partitioning for an entire disk, you will next x
x be asked which disk should be used. x
x x
x Partitioning method: x
x x
x Guided - use entire disk x
x Guided - use entire disk and set up LVM x
x Guided - use entire disk and set up encrypted LVM x
x Manual x
x x
x <Go Back>
This message shows Manual.
Then I select "manual" and I can select usb drive partitions as follows.
lqqqqqqqqqqqqqqqqqqqqqqqqu [!!] Partition disks tqqqqqqqqqqqqqqqqqqqqqqqqqk
x x
x This is an overview of your currently configured partitions and mount x
x points. Select a partition to modify its settings (file system, mount x
x point, etc.), a free space to create partitions, or a device to x
x initialize its partition table. x
x x
x Guided partitioning x
x Configure software RAID x
x Configure the Logical Volume Manager x
x Configure encrypted volumes x
x x
x SCSI1 (0,0,0) (sda) - 2.0 GB JetFlash Transcend 2GB x
x > #1 primary 2.0 GB fat32 x
x x
x Undo changes to partitions x
x Finish partitioning and write changes to disk x
x x
x <Go Back> x
x
But,in nimbus, I cannot select manual and select partitions.
Debian installer shows only "Undo changes to partitions" and x
"Finish partitioning and write changes to disk" as follows.
lqqqqqqqqqqqqqqqqqqqqqqqqu [!!] Partition disks tqqqqqqqqqqqqqqqqqqqqqqqqqk
x x
x This is an overview of your currently configured partitions and mount x
x points. Select a partition to modify its settings (file system, mount x
x point, etc.), a free space to create partitions, or a device to x
x initialize its partition table. x
x Undo changes to partitions x
x Finish partitioning and write changes to disk x
