I am trying to get a magnetic card reader to work with Guruplug stock image. On a usual x86/x64 linux install the card reader is recognized by the kernel with the following details in dmesg
[75412.579376] generic-usb 0003:04F2:0760.0005: input,hidraw1: USB HID v1.11 Keyboard [Chicony USB Keyboard] on usb-0000:00:1d.0-2/input0lsusb
[75412.615189] input: Chicony USB Keyboard as /devices/pci0000:00/0000:00:1d.0/usb6/6-2/6-2:1.1/input/input11
[75412.615262] generic-usb 0003:04F2:0760.0006: input,hiddev96,hidraw2: USB HID v1.11 Device [Chicony USB Keyboard] on usb-0000:00:1d.0-2/input1
Bus 006 Device 004: ID 1130:0001 Tenx Technology, Inc.
when I do tail -f /dev/input/mice
I get an ouput when I swipe a card through the reader. Now for the guruplug device side of the things.dmesg
usb 1-1.3: new low speed USB device using orion-ehci and address 3lsusb
usb 1-1.3: configuration #1 chosen from 1 choice
Bus 001 Device 003: ID 1130:0001 Tenx Technology, Inc.
Tailing doesn't ouput anything on neither usb device, and the device itself hangs. Any ideas what I would need to change/install to get this to work?
It's a usb device ....