victor
Newbie
Karma: 0
Posts: 11
|
 |
« on: June 05, 2009, 11:15:26 PM » |
|
after dist-upgrade,my pogoplug can't running,the following is serial information,who can tell me what caused it, appreciate it!
by the way I use NFS as my rootfs.
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
Using egiga0 device
TFTP from server 192.168.0.8; our IP address is 192.168.0.16
Filename 'uImage'.
Load address: 0x2000000
Loading: #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
##########################################
done
Bytes transferred = 2207224 (21adf8 hex)
## Booting image at 02000000 ...
Image Name: Linux-2.6.30-rc6
Created: 2009-06-01 15:16:36 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2207160 Bytes = 2.1 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
Linux version 2.6.30-rc6 (victor@victor-desktop) (gcc version 4.2.1) #3 PREEMPT Mon Jun 1 23:16:12 CST 2009
CPU: Feroceon 88FR131 [56251311] revision 1 (ARMv5TE), cr=00053177
CPU: VIVT data cache, VIVT instruction cache
Machine: Marvell SheevaPlug Reference Board
Memory policy: ECC disabled, Data cache writeback
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 65024
Kernel command line: console=ttyS0,115200 mtdparts=nand_flash:0x100000@0x000000(u-boot),0x400000@0x100000(uImage),x01f800000@0x500000(rootfs) rw root=/dev/nfs rw nfsroot=192.168.0.8:/victor/ubuntu ip=192.168.0.16:192.168.0.8:::DB88FXX81:eth0:none
NR_IRQS:114
PID hash table entries: 1024 (order: 10, 4096 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 256MB = 256MB total
Memory: 254208KB available (4076K code, 952K data, 116K init, 0K highmem)
SLUB: Genslabs=13, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Calibrating delay loop... 1192.75 BogoMIPS (lpj=5963776)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 520 bytes
NET: Registered protocol family 16
Kirkwood: MV88F6281-A0, TCLK=200000000.
Feroceon L2: Enabling L2
Feroceon L2: Cache support initialised.
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
cfg80211: Using static regulatory domain info
cfg80211: Regulatory domain: US
(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
(2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm)
(5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
cfg80211: Calling CRDA for country: US
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
NET: Registered protocol family 1
JFFS2 version 2.2. (NAND) 漏 2001-2006 Red Hat, Inc.
msgmni has been set to 497
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xf1012000 (irq = 33) is a 16550A
console [ttyS0] enabled
loop: module loaded
Driver 'sd' needs updating - please use bus_type methods
MV-643xx 10/100/1000 ethernet driver version 1.4
mv643xx_eth smi: probed
net eth0: port 0 with MAC address 00:50:43:a6:20:1d
libertas_sdio: Libertas SDIO driver
libertas_sdio: Copyright Pierre Ossman
NAND device: Manufacturer ID: 0xad, Chip ID: 0xdc (Hynix NAND 512MiB 3,3V 8-bit)
Scanning device for bad blocks
mtd: partition size too small (0)
Creating 3 MTD partitions on "orion_nand":
0x000000000000-0x000000100000 : "u-boot"
0x000000100000-0x000000500000 : "uImage"
0x000000500000-0x000020000000 : "root"
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
orion-ehci orion-ehci.0: Marvell Orion EHCI
orion-ehci orion-ehci.0: new USB bus registered, assigned bus number 1
orion-ehci orion-ehci.0: irq 19, io mem 0xf1050000
orion-ehci orion-ehci.0: USB 2.0 started, EHCI 1.00
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver ums-datafab
usbcore: registered new interface driver ums-freecom
usbcore: registered new interface driver ums-jumpshot
usbcore: registered new interface driver ums-sddr09
usbcore: registered new interface driver ums-sddr55
mice: PS/2 mouse device common for all mice
rtc-mv rtc-mv: rtc core: registered rtc-mv as rtc0
i2c /dev entries driver
Linux video capture interface: v2.00
zc0301: V4L2 driver for ZC0301[P] Image Processor and Control Chip v1:1.10
usbcore: registered new interface driver zc0301
usbcore: registered new interface driver uvcvideo
USB Video Class driver (v0.1.0)
mmc0: mvsdio driver initialized, lacking card detect (fall back to polling)
mv_xor_shared mv_xor_shared.0: Marvell shared XOR driver
mv_xor_shared mv_xor_shared.1: Marvell shared XOR driver
mv_xor mv_xor.0: Marvell XOR: ( xor cpy )
mv_xor mv_xor.1: Marvell XOR: ( xor fill cpy )
mv_xor mv_xor.2: Marvell XOR: ( xor cpy )
mv_xor mv_xor.3: Marvell XOR: ( xor fill cpy )
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
oprofile: using timer interrupt.
TCP cubic registered
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
lib80211: common routines for IEEE802.11 drivers
rtc-mv rtc-mv: setting system clock to 2011-02-20 19:00:18 UTC (1298228418)
IP-Config: Guessing netmask 255.255.255.0
IP-Config: Complete:
device=eth0, addr=192.168.0.16, mask=255.255.255.0, gw=255.255.255.255,
host=DB88FXX81, domain=, nis-domain=(none),
bootserver=192.168.0.8, rootserver=192.168.0.8, rootpath=
Looking up port of RPC 100003/2 on 192.168.0.8
eth0: link up, 100 Mb/s, full duplex, flow control disabled
Looking up port of RPC 100005/1 on 192.168.0.8
VFS: Mounted root (nfs filesystem) on device 0:13.
Freeing init memory: 116K
* Filesystem type 'fusectl' is not supported. Skipping mount.
[ OK ]ting preliminary keymap...
[ OK ]rting kernel event manager...
* Loading hardware drivers... udevadm trigger is not permitted while udev is unconfigured.
[ OK ]ding kernel modules... * Loading manual drivers...
[ OK ]ting kernel variables (/etc/sysctl.conf)...
[ OK ]ting kernel variables (/etc/sysctl.d/10-console-messages.conf)...
* Setting kernel variables (/etc/sysctl.d/10-network-security.conf)... error: "net.ipv4.tcp_syncookies" is an unknown key
[fail]
[ OK ]ivating swap...
[ OK ]rting early crypto disks...
[ OK ]rting remaining crypto disks...
* Checking file systems... fsck 1.41.4 (27-Jan-2009)
[ OK ]
[fail]nting local filesystems...
[ OK ]ivating swapfile swap...
[fail]figuring network interfaces...
[ OK ]rting system log daemon...
[ OK ]rting kernel log daemon...
* Starting OpenBSD Secure Shell server sshd PRNG is not seeded
[fail]
[ OK ]rting Samba daemons
[ OK ]rting periodic command scheduler crond
|
