boot problems

[rappa]

I'm not able to boot my plug after my SD card failed.  Just get

Connected.
512 MB

CPU : Marvell Feroceon (Rev 1)

Streaming disabled
Write allocate disabled


USB 0: host mode
PEX 0: interface detected no Link.
Net:   egiga0 [PRIME], egiga1
Hit any key to stop autoboot:  0

NAND read: device 0 offset 0x100000, size 0x400000

Reading data from 0x4ff800 -- 100% complete.
 4194304 bytes read: OK
## Booting image at 00800000 ...
   Image Name:   Linux-2.6.30.4
   Created:      2009-08-10   6:47:49 UTC
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    2626008 Bytes =  2.5 MB
   Load Address: 00008000
   Entry Point:  00008000
   Verifying Checksum ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.


And it hangs here forever.  Is there anything I can do get it working again or should I toss it in the closet junk pile?  Thanks.

[rappa]

Does anyone know if there is support available from Marvel?  Really don't want to have to toss this thing in the trash can.

[birdman]

Did the card fail or the card reader?

If it's "just" the card you could re-install from scratch onto a new card using the SheevaPlug Installer, which is mentioned in other threads around here.