I'm not able to boot my plug after my SD card failed. Just get
CPU : Marvell Feroceon (Rev 1)
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
NAND read: device 0 offset 0x100000, size 0x400000
Reading data from 0x4ff800 -- 100% complete.
4194304 bytes read: OK
## Booting image at 00800000 ...
Image Name: Linux-220.127.116.11
Created: 2009-08-10 6:47:49 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2626008 Bytes = 2.5 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
And it hangs here forever. Is there anything I can do get it working again or should I toss it in the closet junk pile? Thanks.