In this crowd I am a total newbie. I did manage to get the supplied ubuntu image installed using tftp and nfs. I have installed lighttpd, mysql, php5 (wordpress), samba, transmission and it all works great.
Today I was moving some stuff I got off of torrents around (using an external USB HDD). I noticed performance was sluggish, and had windows have a few complaints like the share was disconnected. They were immediately resolved though. I typed in the top command in the console, and smbd (or something like that, the samba daemon) was about 96% cpu utilization. After that my console connection crashed. I rebooted the plug, couldn't connect.
After connecting using the serial cable, this is the output I get when booting:
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** MARVELL BOARD: SHEEVA PLUG LE
U-Boot 1.1.4 (Mar 2 2009 - 12:16:00) Marvell version: 3.4.16
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CEE60
Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz
DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS base 0x00000000 size 256MB
DRAM CS base 0x10000000 size 256MB
DRAM Total size 512MB 16bit width
Flash: 0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
CPU : Marvell Feroceon (Rev 1)
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
NAND read: device 0 offset 0x100000, size 0x400000
Reading data from 0x4ff800 -- 100% complete.
4194304 bytes read: OK
## Booting image at 00800000 ...
Image Name: Linux-220.127.116.11
Created: 2009-04-04 1:49:44 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2070252 Bytes = 2 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... Bad Data CRC
I'm booting off the SDIO following instructions on the wiki
. When I printenv, all the required settings are the same - I wonder is my NAND flash bad?
Hope this is the right forum. Any input would be much appreciated! Thank you!