• Home
  • Help
  • Search
  • Login
  • Register
Pages: [1]
Author Topic: eSheeva: Nand Boot: Stuck at 'done booting Kernel'  (Read 1081 times)
dced
Newbie
*

Karma: 0
Posts: 1


View Profile
« on: August 01, 2010, 11:24:15 PM »

Hi,

I've recently received my esheeva plug.

I've tweaked the boot to support the multiboot (SD & NAND).

The SD boot works fine but not anymore the NAND.

For some unknown reasons the NAND get stuck at 'done booting the kernel'. See below:

Code:


NAND read: device 0 offset 0x100000, size 0x400000

Reading data from 0x4ff800 -- 100% complete.
 4194304 bytes read: OK
## Booting image at 00800000 ...
   Image Name:   Linux-2.6.22.18
   Created:      2009-03-19   9:18:16 UTC
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    2106696 Bytes =  2 MB
   Load Address: 00008000
   Entry Point:  00008000
   Verifying Checksum ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.

Here is the output of printenv

Code:

Marvell>> printenv
baudrate=115200
loads_echo=0
rootpath=/mnt/ARM_FS/
netmask=255.255.0.0
console=console=ttyS0,115200
CASset=min
MALLOC_len=1
ethprime=egiga0
bootargs_root=root=/dev/mtdblock2 ro
ethmtu=1500
usb0Mode=host
nandEcc=1bit
ethact=egiga0
serverip=10.10.0.2
ipaddr=10.10.0.1
cesvcid=ULULULULULULPPULULULULULDA
bootargs_end=:::DB88FXX81:eth0:none
image_name=uImage
standalone=fsload 0x2000000 $(image_name);setenv bootargs $(console) root=/dev/mtdblock0 rw ip=$(ipaddr):$(serverip)$(bootargs_end) $(mvPhoneConfig); bootm 0x2000000;
mvPhoneConfig=mv_phone_config=dev0:fxs,dev1:fxs
mvNetConfig=mv_net_config=(00:11:88:0f:62:81,0:1:2:3),mtu=1500
yuk_ethaddr=<Removed>
netretry=no
rcvrip=169.254.100.100
loadaddr=0x02000000
autoload=no
ethaddr=00:50:43:01:4C:1F
run_diag=no
arcNumber=2678
bootargs_console=console=ttyS0,115200
bootcmd_mmc_init=mmcinit; ext2load mmc 0:1 0x01100000 /uInitrd; ext2load mmc 0:1 0x00800000 /uImage
bootcmd_mmc=setenv bootargs $(bootargs_console); run bootcmd_mmc_init; bootm 0x00800000 0x01100000
mtdpartitions=mtdparts=nand_mtd:0x400000@0x100000(uImage),0x1fb00000@0x500000(rootfs) rw root=/dev/mtdblock1 rw ip=10.4.50.4:10.4.50.5:10.4.50.5:255.255.255.0:DB88FXX81:eth0:none
bootcmd=run bootcmd_mmc , run bootcmd_nand
bootargs=console=ttyS0,115200 mtdparts=nand_mtd:0x400000@0x100000(uImage),0x1fb00000@0x500000(rootfs) rw root=/dev/mtdblock1 rw ip=10.4.50.4:10.4.50.5:10.4.50.5:255.255.255.0:DB88FXX81:eth0:none nand read.e 0x800000 0x100000 0x400000
bootcmd_nand=setenv bootargs $(bootargs_console) $(mtdpartitions); nand read.e 0x00800000 0x00100000 0x00400000; bootm 0x00800000
stdin=serial
stdout=serial
stderr=serial
mainlineLinux=yes
enaMonExt=no
enaCpuStream=no
enaWrAllo=no
pexMode=RC
disL2Cache=no
setL2CacheWT=yes
disL2Prefetch=yes
enaICPref=yes
enaDCPref=yes
sata_dma_mode=yes
netbsd_en=no
vxworks_en=no
bootdelay=3
disaMvPnp=no
enaAutoRecovery=yes

Environment size: 1885/131068 bytes
Marvell>>



Logged

Pages: [1]
Print
Jump to: