I'm following these instructions
http://www.openplug.org/plugwiki/index.php/Installing_Debian_To_Flash and am trying to use the 2.6.32.11 kernel from here
http://sheeva.with-linux.com/sheeva/ .
When I get to the bootm command I get:
Marvell>> bootm 0x0400000 0x0800000
## Booting image at 00400000 ...
Image Name: Debian kernel
Created: 2010-04-04 10:27:18 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1431196 Bytes = 1.4 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
OK
## Loading Ramdisk Image at 00800000 ...
Image Name: debian-installer ramdisk
Created: 2010-04-04 10:27:18 UTC
Image Type: ARM Linux RAMDisk Image (gzip compressed)
Data Size: 2616636 Bytes = 2.5 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
Error: unrecognized/unsupported machine ID (r1 = 0x0000020f).
Available machine support:
ID (hex) NAME
00000690 Marvell DB-88F6281-BP Development Board
00000691 Marvell RD-88F6192-NAS Development Board
00000692 Marvell RD-88F6281 Reference Board
00000831 Marvell SheevaPlug Reference Board
0000085b QNAP TS-119/TS-219
000009c6 QNAP TS-41x
00000915 Marvell OpenRD Base Board
00000939 Marvell OpenRD Client Board
Please check your kernel config and/or bootloader.
Reading other mentions of this error it says that their hardware isn't in the list but I'm using a normal SheevaPlug which I assume is the line with ID 831 in the supported list. If not the how can I tell what ID my device has and how can I get it to boot?
