by flashing a wrong uboot i managed to bricck my guruplug
After powering it, the red light flashes for 1 second, and then the green light is the only one burning
after reading i found that the guruplug-installer should work
so i connect the jtag to my linux pc, and the guruplug to the jtag
then ./runme.sh uboot.guruplug.bin
and i get this:
[root@smeserver guruplug-installer]# ./runme.sh uboot.guruplug.bin
**** Preparing environment variables file ...
**** Burning uboot and environment variables ... This will take few minutes ...
Open On-Chip Debugger 0.2.0-in-development (2009-05-17-10:32) svn:1800M
BUGS? Read http://svn.berlios.de/svnroot/repos/openocd/trunk/BUGS
$URL: http://svn.berlios.de/svnroot/repos/openocd/trunk/src/openocd.c $
2000 kHz
dcc downloads are enabled
Error: JTAG communication failure, check connection, JTAG interface, target power etc.
Error: trying to validate configured JTAG chain anyway...
Error: Could not validate JTAG scan chain, IR mismatch, scan returned 0x00. tap=feroceon.cpu pos=0 expected 0x1 got 0
Warn : Could not validate JTAG chain, continuing anyway...
Warn : value captured during scan didn't pass the requested check:
Warn : captured: 0x00 check_value: 0x01 check_mask: 0x0F
Warn : no telnet port specified, using default port 4444
Warn : no gdb port specified, using default port 3333
Warn : no tcl port specified, using default port 6666
Error: unknown EmbeddedICE version (comms ctrl: 0x00000000)
Error: unexpected Feroceon EICE version signature
Error: timed out while waiting for target halted
Runtime error, file "./openocd/./board/guruplug.cfg", line 24:
**** openocd FAILED
**** Is the mini USB cable connected?
**** Try powering down, then replugging the Sheevaplug
[root@smeserver guruplug-installer]# ./runme.sh uboot.guruplug.bin
