Wheezy is installed on an eSATA disk and nand is only used for uBoot.
But init seem to test it and the leds during boot.
I can read this in my logwatch :
Code:
--------------------- Kernel Begin ------------------------
WARNING: Kernel Errors Present
Buffer I/O error on device mtdblo ...: 10 Time(s)
EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro ...: 1 Time(s)
end_request: I/O error, dev mtdblock0, ...: 10 Time(s)
end_request: I/O error, dev mtdblock1, ...: 12 Time(s)
end_request: I/O error, dev mtdblock2, ...: 2 Time(s)
leds-gpio: probe of leds-gpio failed with error -22 ...: 1 Time(s)
uncorrectable error : ...: 34 Time(s)
---------------------- Kernel End -------------------------
WARNING: Kernel Errors Present
Buffer I/O error on device mtdblo ...: 10 Time(s)
EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro ...: 1 Time(s)
end_request: I/O error, dev mtdblock0, ...: 10 Time(s)
end_request: I/O error, dev mtdblock1, ...: 12 Time(s)
end_request: I/O error, dev mtdblock2, ...: 2 Time(s)
leds-gpio: probe of leds-gpio failed with error -22 ...: 1 Time(s)
uncorrectable error : ...: 34 Time(s)
---------------------- Kernel End -------------------------
How can I say to the kernel to stop testing NAND and leds ?
thanks.






