• Home
  • Help
  • Search
  • Login
  • Register
  Show Posts
Pages: [1]
1  Linux Stuff / General Linux questions / Re: question about wvdial and ppp on: July 17, 2012, 02:44:44 PM
Did you solve it?

I'm running into the exact same problem right now unfortunately...
2  Hardware and U-Boot firmware / U-Boot stuff / Re: Guruplug Server Plus - U-Boot Does Not Appear to Run on: December 16, 2011, 07:36:13 AM
My solution was to hold the reset button while starting runme.sh and quickly letting go.

But after spending ages trying to recompile uboot for ext2load without succes, I tried flashing a binary one off the wiki.
Since then my Guruplug hasn't done anything, at all.

The jtag link comes up but openocd quits with:

Error: timed out while waiting for target halted
3  General Category / General Discussion / Re: GuruPlug JTAG WinXP Drivers on: June 09, 2010, 05:34:25 AM
Why is it that all the assholes using those FTDI chip just HAVE to change the vid/pid in this thing...

It's not that difficult to just change the description and leave the vid/pid intact for all the drivers in the world to just work, especially since the FT2232 is the only chip on this board and is just used for it's intended purposes...
Pages: [1]