• Home
  • Help
  • Search
  • Login
  • Register
  Show Posts
Pages: 1 [2]
16  Hardware and U-Boot firmware / Hardware / Re: SheevaPlug Development seemed to be in reset mode... on: April 05, 2009, 08:32:51 PM
It turns out the device was working properly. I can access both U-boot and the Ubuntu version of the device. The tricky thing is to plug in the USB in the computer. Then hot plug the device to power. After that, immediately get your terminal program to connect (after USB detection and etc.) Wait for a while since the boot time is slow to make sure you can capture that. Oh, I wish they had a little button on the outside to do reset only on the Marvell's CPU such that this would not be so tricky to play with.
17  Hardware and U-Boot firmware / Hardware / SheevaPlug Development seemed to be in reset mode... on: April 04, 2009, 11:54:51 PM
I tried to use the Pluggable computer through the diagnostic USB port through COM1 and nothing came up in the console. So, I tried to use TRACE32 to download U-boot into the device. Trace 32 detected the processor as in reset mode. Since I could communicate to the USB chip port but not the device afterward, I suspect the Marvell processor may be in reset mode.

Have anyone experience this problem? Is this normal?

Any advice would be greatly appreciated.
Pages: 1 [2]