Latest posts of: JimmyLarsson

Show Posts
Pages: [1]

1	Hardware and U-Boot firmware / Hardware / Re: guruplug server plus arrived but died	on: May 17, 2010, 11:58:05 PM
Quote from: daemondust on May 17, 2010, 07:04:39 PM I can get eth0 or eth1 (I haven't tried both at the same time) to come up at 100 meg, but cycle link up/link down if I try to bring them up at 1 gig. Is it possible to lock the speed to 100 in the plug? I am not able to change speed of the switch right now... /Jimmy

2	Hardware and U-Boot firmware / Hardware / Re: guruplug server plus arrived but died	on: May 17, 2010, 09:39:07 AM
Same thing happened to me. I got 2 units server plus. The first one worked fine at first. I was able to connect over wlan. A few minutes after connecting an ethernet connector it went dead. The upmost led (power on) went red and reboot didnt help until I connected the ethernet cable. Without ethernet connected it works great. So I tested my second one. Same issue. The only difference is that this seems to be slightly more stabile. One ethernet-cable connected works fine until I start to do some file transfer, then it hangs. With 2 ethernet connected it wont even boot. With no cables connected it works great. WorkED. Until now. Suddenly one of them said POOOF and went dead. (Does anyone know if there is a fuse that can be replaced without voiding warranty?) 230v. Best regards Jimmy

Pages: [1]