Thamk you for your answer but sorry, I wasn't clear enough. I meant the memory addresses of the last two u-boot commands.

I'm trying to follow this wiki page: http://www.plugcomputer.org/plugwiki/index.php/Re-building_the_kernel_and_U-Boot
I'd like to test the u-boot before writing to nand; the wiki says:

 
setenv serverip 192.168.***.***
setenv ipaddr 192.168.***.***
tftp 0x6400000 u-boot.kwb
go 0x0c100000

This is not working for me.
My questions are:
1. Shouldn't the 2 addresses (tftp and go commands) be the same? (I tried to change them but without success)
2. Is the u-boot binary image for running from RAM the same as the one for flashing the nand?
3. Do I have to use the u-boot.kwb OR u-boot.img file?

Thank you for any help

Hi everybody.
Do you know if uap8xxx driver supports WDS (wireless distribution system) and how to configure it?
It would be useful to have the plug communicating with an AP withouth switching to Wi-Fi client mode.

Thank you and regards
Luspa